Fireplaces-Woodstoves
Authorized Dealer
Recommended heating area750 - 2,200 ft²
​
Overall firebox volume
2.5 ft³
​
Maximum burn time
8 Hours
​
EPA loading volume1.69 ft³
Maximum heat output-dry cordwood 80,000 BTU/h
​
Minimum overall heat output rate14,200 BTU/h (4.16 kW)
​
Maximum overall heat output rate48,200 BTU/h (14.13 kW)
​
Average efficiency-dry cordwood (HHV) 65.7 %
​
Average efficiency-dry cordwood (LHV) 73 %
​
Optimum efficiency 74%
​
Optimum heat transfer efficiency 71%
​
Average particulate emission rate1.14 g/h
​
Average CO53 g/h
HE250R
-
Designed mainly for heating
-
Large contemporary fireplace with single door
-
EPA 2020 certified
-
Non-catalytic combustion technology
-
Installation authorized on the Island of Montreal
-
Firestop made of high density insulation board
-
Minimalist Ventis distinctive louver
-
Molded refractory stones
-
6" Ventis stainless steel anchor plate included
-
Fresh air intake adapter and andiron included
-
Performances based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%.
-
Optimum overall efficiency at a specific burn rate (LHV).
-
This appliance is officially tested and certified by an independent agency.
-
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³. Other performances are based on a fuel load prescribed by the standard. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.
-
As measured per CSA B415.1-10 stack loss method.
-
Higher Heating Value of the fuel.
-
Lower Heating Value of the fuel.
-
The optimum heat transfer efficiency is for the low burn rate (using HHV) and represents the appliance’s ability to convert the energy contained in the solid fuels into energy transferred to the room in the form of heat and does not take into account the chemical losses during combustion.
-
Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure.
-
Carbon monoxyde.
HE350
Fuel type Dry cordwood (16" recommended)
​
Recommended heating area1,000 - 2,800 ft²
​
Overall firebox volume 4.28 ft³
EPA loading volume 4.28 ft³
​
Maximum burn time11 Hours
​
Maximum heat output-dry cordwood 95,000 BTU/h
​
Minimum overall heat output rate16,900 BTU/h (5.0 kW)
​
Maximum overall heat output rate 43,000 BTU/h (12.6 kW)
​
Average efficiency-dry cordwood (HHV) 64%
​
Average efficiency-dry cordwood (LHV) 69%
​
Optimum efficiency 70%
​
Optimum heat transfer efficiency 69%
​
Average particulate emission rate1.6 g/h
​
Average CO159.0 g/h
Ventis HE350 Zero Clearance Wood Fireplace is an elegant, high-performance fireplace. It burns up to 10 hours and holds up to 60 pounds of hardwood, the firebox can hold up to 25-Inches of log. The fireplace uses an automated air intake system that allows the fire to reach the perfect temperature before going into slow burn mode. Two giant double glass doors provide an impressive viewing area, making it the centerpiece of any room.
-
Designed mainly for heating large spaces
-
Patented design of the intelligent air control mechanism
-
Luxurious effect created by an eye-catching fireplace
-
Large glass surface
-
EPA 2020 certified
-
Non-catalytic combustion technology
-
Installation authorized on the Island of Montreal
-
Firestop made of high density insulation board
-
176 CFM blower included
-
8" Ventis stainless steel anchor plate included
-
Fresh air intake adapter included